Control Voltage Pedal

Linear and Oscillating Control Voltage for Analog Synths.

Performing with an Analog Synth, consists mainly of real time Timbre shaping. For this purpose 24dB Resonant Filters and Envelope Generators were created.

The Analog performer will share his attention between the keyboard manual and the panel.

Intended to release your hands to other tasks, this Control Voltage(CV) Pedal can control most synthesizers or other gear that has a Control Voltage input.

This pedal can produce the following signals:

0 to +5V : As used in most current equipment both analog and digital. The current moog line works with this standart.

0 to +10V : Used in most vintage synths. Moog, Yamaha, Roland, Sequential, Arp etc...

-5 to +5 : Used by Analog Korg: Mono/Poly, MS-10, MS-20, MS-50, Polysix, PS Modular Series, Trident, VC-10 Vocoder among others.

The pedal has an analog Low Frequency Oscillator (LFO).

More than just controlling the synth in linear mode, it can also modulate it in oscillating mode using its own LFO.

This feature will add more modulation possibilities to you analog synthesizer.

When the switch is pressed, the pedal will change from linear modulation to oscillating modulation. Frequency ranges from 0.1Hz to 20Hz. The position of the pedal will control the LFO's depth.

There is also a rotary knob that changes the frequency of the LFO.

Pressing the button again will make it return to linear control.

The pedal is made in stainless steel, built to endure the worst operational conditions.

Runs on a DC adapter or on a 9 volt battery (not included).

Watch this Quicktime video below. You will see and hear a short clip of one of these pedals controlling a MS20 Low Pass Filter in linear mode and then controlling a Polysix filter in both linear and oscillating modes.

Will ship worldwide.